VCM II Recovery - Connection has been broken
23/12/2019
It is laptop USB issue, I think it is not enough power amps not volts from some laptops.Power it from car.Instal Ford IDS v86 or just install the Ford VCM2 Manager v2.5.6 Try tgen a Recovery Mode. Or use a new SD Card 4Gb already formated I intrepted a firmware updatr into my genuine VCM2 and I used Manager v2.5.6 in win 7 32bit and all was dine again Good luck.
Warning: Please also use our software when using our equipment, otherwise we cannot provide after-sales service for you.
https://www.obdsvs.com/car-diagnostic-tool/ford-mazda-jaguar-landlover/vcm-ids-ii-with-original-design-full-new-chips-vcm2-for-ford-mazda-land-rover-and-jaguar.html
https://www.obdsvs.com/car-diagnostic-tool/ford-mazda-jaguar-landlover/VCM-IDS-II-Vcm2-for-Ford-v115.01-hard-disk-version-for-ford.html